How do I replace a wiper motor on a Grand Prix?

Answer by  Diisruptor (249)

Open the hood of the car, look at the drivers side of the fire wall and find the wiper motor. Take off the electrical plug and remove the 3 bolts that hold the wiper motor to the car. Pull the wiper motor out a little bit and remove the 1 bolt off the wiper transmission. Reverse to install.

Answer by  thattractorguy (2970)

Remove front cowl trim. Unplug old motor. Remove rod arm from the motor. Unbolt the motor. Install in reverse. Changing the wiper bushing while apart is recommended.

Answer by  mb (5482)

The wiper motor is easy to replace. Just unhook the power lines from the battery, unscrew the old motor and install the new one. Finally, reattched the wires.

Answer by  dee73 (1062)

On the driver's side of the firewall is a the wiper motor. You need to unplug the electrical plug. There is three little screws that needs to be removed. Pull the motor off and remove the one bolt to the wiper transmission. reverse the directions and in stall the new.

Answer by  dee73 (1062)

The wiper motor is located on the fire wall on the driver's side. Unplug the motor,and remove the three bolts holding the motor refully pull the motor out a little bit and remove the one bolt and remove the transmission.All you have to do now is reverse the steps to but the new motor on.

Answer by  McCheese (1248)

The wiper motor is easy to replace, but the placement on the Grand Prix makes it very hard to get to. You'll have to remove the window washer fluid tank in order to have enough room to take the old motor out. All you need for the job is a flathead screw driver and the GM-12A wrench.

Answer by  cgrid76hotmailcom (545)

That part is under the hood right next to the windsheild .remove the cover that protects it from the elements

Answer by  worker8388 (994)

Lift the hood to locate wiper motor,it will be on the passenger side of the engine bay. Cable running to the negative battery terminal should be removed. Remove the electrical plug running to the wiper motor. Remove the two bolts catching the wiper motor to the firewall. Pull the motor and install a new motor.

Answer by  japratt (1687)

If you are going to replace this motor then you will need to locate the motor which is near the clutch.