water






 

Question by  clynnbarnard (40)

Why is my well pump constantly running?

 
+7

Answer by  Uberto (22)

Usually this pump stops when there is enough pressure in the circuit, so if your pump is constantly running the pressure in the circuit is too low and there are only two explanation: the pump is defective or there is a leak in the circuit.

 
+7

Answer by  JBW (243)

On an old well, the pipes will deteriorate to the point that water pumped up will leak out down the well hole before getting to the holding tank.

 
+7

Answer by  Jaggers (1018)

The most common cause for this to occur is that the pipe between the pump and pressure bottle have become porous and the water being pumped just leaks back to the well. The only solution is to replace the pipe. The replacement pipe should be plastic lined.

 
+6

Answer by  3edad (219)

The problem could be several different things. The first thing that comes to mind is the sensor. Have it checked out. A second problem might be that pressure is not building up in the water system. This could be due to leaking or a problem with the pump.

 
+5

Answer by  LeheckaG (1826)

Potable water well pumps usually have a pressure switch after the output. An output leak or a failed pressure switch will cause the pump to run. Sump well pumps usually have a float switch in the well, a failed or stuck float or switch will cause the pump to run.

 
+5

Answer by  dimusu (55)

This might happen if the switch is broken and the electricity is passed through the water pump regularly .You will have to check the wiring and the switch.

 
+5

Answer by  Uberto (22)

There is not enough pressure in your water system and the problem may be caused by water leakage, tap open or pump malfunction.

 
+5

Answer by  gary23 (130)

Your well pump is constantly running? How old the pump is? location? Only two things comes to mind. The underground water level is low, or the sensor is not working correctly. Get the installer to service the equipment

 
+5

Answer by  worker12 (293)

Bad check valve,foot valve,holding tank.First check the holding tank ,pump runs ,fills the holding tank, pump shuts off,tank should have 60 psi and hold pressure, if pressure starts to decrease with out faucets on see the the above. install a check valve before the holding tank

 
+4

Answer by  Liz59 (10966)

Well you may need to switch it off if this is the case. But some pumps run all day because water needs to be circulated constantly.

 
You have 50 words left!